Mazda Factory Race (MFR) Rear Stationary Gear Bearing

Description

Genuine Mazda Factory Race Part
Use in place of stock rear bearing. 3-window type. Recommended for any engine used at 8000 rpm and above. Increases oil flow to the inside of eccentric shaft and to rotors.

If you are installing this bearing in to a Manual RX-7 FD3s of 231ps RX-8 Rear Stationary Gear we would recommend getting an indexing groove cut in to the rear face of the stationary gear in order to locate and hold this bearing correctly. The location should be in the same place as that found on Auto Rear Stationary gears and those earlier then the FD3s. Stationary gears from the Automatic FD3s and RX-8 including the 192ps manual RX-8 should have this indexing groove in them already.

These bearings are special order only and can take up to 6 weeks for delivery. They are sometimes out of stock at Mazda HQ Japan so can take longer. we would recommend ordering your competition bearings early to avoid disappointment.

It is also recommended to run increased oil pressure with race bearings please take a look at the regulators we offer for your vehicle. If you cannot find what you require please do contact us for further help.

THESE BEARINGS ARE SOLD INDIVIDUALLY

When using this rear bearing in stationary gears that have a retaining screw a locating notch will need to be milled in to the back of the rear stationary gear prior to installation.